Bose 131 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Bose 131. Bose 131 18 halaman. Marine loudspeaker system
Juga untuk Bose 131: Panduan Pemilik (37 halaman), Panduan Pemilik (23 halaman), Panduan Servis (7 halaman), Panduan Servis (7 halaman), Manual (7 halaman)

Halaman Cetak

Installing Your Speakers From The Rear Of The Bulkhead

Connect the speakers. Be sure the receiver or

A 13

amplifier is turned OFF. If possible, disconnect the

power source. Use the supplied silicone-filled wire

nuts to secure the ends of each wire pair. Place the

stripped end of the positive (+) right channel receiver

wire together with the stripped end of the positive (+)

right speaker wire. Place the wire nut over the ends of

the wires and turn it in a clockwise direction. Turn it

with firm pressure until it stops; there should be no

uninsulated wire visible. Repeat this procedure for the

remaining wire end.

Repeat the above procedure for the left speaker.

Check that all connections are made positive to

positive (+ to +) and negative to negative (– to –).

Tighten any loose connections before you plug in the

receiver or amplifier and turn it on.

Note: Twisting the ends of the wires together is not

necessary.

Tie a knot in each joined wire pair to protect the

A 14

connection from being pulled apart.

Remove the perforated speaker cone shields

A 15

from the enclosure cartons. Insert the tabs of the

shields into the speaker ports. This helps protect

the speaker cone from potential damage during

the installation process.

Note: For added protection against water entering

the bulkhead, you can apply a generic silicone

sealant between the flange and the mounting

surface.

A 16

Replace the enclosure behind the bulk head and

place the mounting flange so that it interlocks with

the enclosure and lines up with the drilled holes.

Attach the flange to the mounting surface using six

screws.

Next, install six screws through the flange into the

matching holes in the enclosure.

Note: If you plan to use a screw gun to install

the screws, you should first set the gun to its

lowest torque setting (do not exceed 12 inch-

pounds or 135.84 N-cm of torque). If the screw

does not seat properly, finish installing the screw

at the next highest torque setting, or by hand.

October 30, 2001

AM188201_02_V.pdf