Bose 149393 Panduan Pemilik - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Bose 149393. Bose 149393 41 halaman. Direct/reflecting® speaker system

Figure 7

Home theater receiver

connections

2. Use the twin cable assemblies (with two connectors at each end) that are supplied with the

equalizer. Use one connector for the right (R) channel connections and the other connector

for the left (L) channel connections.

3. Connect the amplifier INPUT of the Bose

of the receiver or amplifier. Connect right channel to right channel and left to left.

4. Connect the amplifier OUTPUT of the active equalizer to the MAIN AMP IN jacks on the

receiver or amplifier. Connect right channel to right channel and left to left.

5. Plug the power cord of the 901 active equalizer into one of the switched outlets on the

receiver so that it will be powered when the receiver is switched on.

Note: This connection method does not allow you to connect a tape deck directly to the active

equalizer. Connect it to the receiver instead.

Check to see that the 901 speakers are connected to the receiver MAIN or FRONT speaker

jacks. In this way the 901 active equalizer signals will reach only the 901 speakers – the front

channels of your home theater – and not any non-901 speakers used as center and surround

channels.

Call Bose Corporation for assistance with the connection of additional speakers or signal

processing equipment. Refer to the address information inside the back cover of this guide.

A free booklet is available (USA only): Guide to Optional System Connections for Bose 901

Direct/Reflecting

Speaker Systems. Ask for part number 149393.

901

active equalizer to the PRE AMP OUT jacks

Setting Up