Bose Panaray MA12 Panduan Servis - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Servis untuk Sistem Pembicara Bose Panaray MA12. Bose Panaray MA12 11 halaman. Modular line array loudspeaker
Juga untuk Bose Panaray MA12: Landasan Teknis & Diskusi (36 halaman), Panduan Pengguna (2 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (8 halaman), Panduan Instalasi (7 halaman)

Note: Refer to the figure below for the

following procedures.

1. End Cap Removal

1.1 Using a Phillips-head screwdriver,

remove the six screws (4) that secure the

steel end cap (5) to the housing and grille

trim.

1.2 Gently pull the end cap away from the

housing.

Re-assembly Note: When replacing the end

cap, ensure that it is fully seated against the

housing for an airtight seal. Replace all six

screws to prevent air leaks.

2. Grille Assembly Removal

2.1 Remove the two screws at the front of

each end cap.

2.2 Take the grille trim (14) along with the U-

rubber channel (13) away from the end of

the grille (11).

Disassembly Procedures

3. Driver Removal

2.3 Gently pull the grille assembly away

from the housing. Be careful not to mark

the surface of the grille or the housing.

3.1 Perform procedure 2.

3.2 Using a Phillips-head screwdriver,

remove the sixteen screws (8) that secure

the baffle to the housing.

3.3 Lift the baffle with the six drivers (7) out

of the housing.

3.4 Unplug the driver cable wires from the

driver you wish to remove.

3.5 Using a Phillips-head screwdriver,

remove the four screws (9) that secure the

driver to the baffle. Lift out the driver.