Bose SoundTouch Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Bose SoundTouch. Bose SoundTouch 32 halaman. Wireless pedestal
Juga untuk Bose SoundTouch: Panduan Pemilik (33 halaman), Panduan Memulai Cepat (2 halaman), Panduan Servis (39 halaman), Manual (9 halaman), Panduan Pemilik (20 halaman), Panduan Pemilik (32 halaman), Panduan Memulai Cepat (5 halaman), Mulai dari Sini Manual (20 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pemilik (18 halaman), Panduan Memulai Cepat (5 halaman), Panduan Memulai Cepat (2 halaman)

Halaman Cetak
Bose SoundTouch Panduan Pemilik
Setting Up Your Wave

System setup

Note: Before you start setting up this system, be sure to read
"Important setup options" on page 7.
1.
Place the SoundTouch™ pedestal on a flat, stable surface.
2.
Carefully set your Wave
SoundTouch
pedestal.
TM
• Make sure the rear feet of the Wave
the recesses on top of the SoundTouch
• Make sure the Wave
®
edges of both units are aligned.
Place rear feet
into recesses
3.
Make the connections:
A. Insert the SoundTouch™ pedestal cable into the Bose link
connector.
B. Insert the small plug on the power cord into the connector
labeled AC Power.
C. Plug the other end into a live AC (mains) power outlet.
4.
Unwind and straighten the power cord to ensure the best FM
radio reception. The power cord is used as an antenna.
8 - English
SoundTouch™ Music System
®
music system on top of the
®
music system fit into
®
pedestal.
TM
music system sits flat and the side
®
SoundTouch™
pedestal
A
B

Setting the clock

After plugging in your Wave
easily operated using the remote control. Just aim the remote at
the front panel and press the necessary buttons.
To set the clock:
1.
Press and hold either Time – or Time + for about 1 sec.
Note: Press-and-hold operations require holding the button down
for about one second.
Initially, HOLD TO SET appears on the display and then
quickly changes to – CLOCK SET – as the button is
depressed.
2.
Release the selected Time button.
3.
Press Time – to adjust the displayed time backward or press
Time + to adjust the displayed time forward until it matches
the current time. You can also press and hold for rapid
adjustment.
4.
Wait five seconds for the system to exit the clock setup mode
automatically.
Note: To change the clock display from 12-hour (AM/PM)
time to 24-hour time, see "Changing the time format" on
page 23.
C
Note: If the Wave® SoundTouch
to a power outage or unplugging the unit to move it, all
system settings will be permanently retained. However, the
clock time will only be temporarily stored in backup memory
for up to 48 hours.
SoundTouch™ music system, it is
®
music system loses power due
™