Bose Speakers Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Bose Speakers. Bose Speakers 12 halaman. Bose owner's guide speaker 161

Setup

Testing speaker connections

1. Center the balance control on your receiver or ampliﬁer. Set it

2. Place the 161

3. Play some deep bass passages of music.

The sound should seem to come from a point between the two

speakers. The bass should be full and natural. If not, your connec-

tions may be reversed, causing the speakers to play out of phase.

To correct the problem, make sure the speaker wires are con-

nected + to + and – to –. Then repeat steps 1 – 3.

See the back pages of this guide for a mounting template and

mounting hardware information.

CAUTION: Do not mount the brackets on surfaces that are not

sturdy enough, or that have hazards concealed behind them,

such as electrical wire or plumbing. If you are unsure about install-

ing the bracket, contact a qualiﬁed professional installer.

CAUTION: Do not hang items from the brackets or speakers. The

brackets were designed to support the weight of the speakers

only.

Note: For vertical mounting, mount part A with the hole for screw

C at the bottom. Be sure to tighten all screws.

Note: For Stereo Everywhere

mounting is required.

1. Hold the mounting template in position and mark holes for the

2. Drill holes for the chosen mounting hardware.

3. Mount bracket part A to the wall and mount bracket part B to

4. Secure the speaker with bracket part B to bracket part A

Figure 3

Speaker-bracket

installation

for MONO, if you have that option, and turn it on.

™

speakers less than 6 inches (15 cm) apart, fac-

ing each other.

mounting hardware. If you plan to feed wires through the wall,

mark the speaker wire pilot hole also.

the rear of the speaker (Figure 3).

using screw C. To adjust the angle, loosen screw C slightly,

move the speaker up or down, and retighten screw C.

October 26, 2001

speaker performance, horizontal

AM257524_01_V.pdf