Bose WAVE RADIO III Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Bose WAVE RADIO III. Bose WAVE RADIO III 24 halaman. Owner's guide
Juga untuk Bose WAVE RADIO III: Panduan Pemilik (28 halaman), Panduan Pemilik (28 halaman), Panduan Pemilik (26 halaman), Panduan Pemilik (28 halaman), Panduan Servis (10 halaman)

Halaman Cetak

ETTING

OUR

Unpacking

Please check the shipping carton for the following items:

radio III

Wave

*The appropriate power cord(s) for your region is supplied.

Selecting a location

radio III on a table or other flat

• Place your Wave

surface.

• To enjoy maximum audio performance, place your

radio III across the room from where you will

Wave

be listening.

• For best audio performance, place your Wave

III within two feet of a wall, and avoid placing directly

in a corner.

Notes:

• Do not place your Wave

could interfere with AM reception.

• Do not place your Wave

surface. Like all electrical equipment, it generates some

heat.

• Do not use your Wave

any other place where moisture can get inside.

Connecting to power

1. Insert the small end of the power cord into the con-

nector labeled AC POWER on the rear panel of your

radio III.

Wave

2. Plug the power cord into an electrical outlet.

AC POWER

6 – English

AVE

ADIO

Remote control

(battery installed)

AC power cord(s)*

radio III on a metal surface. It

radio III on a heat-sensitive

radio III in a damp location or

III

3. Unwind and straighten the power cord to ensure the

best reception for FM radio. Your Wave

uses the power cord as an antenna.

Setting the clock

After plugging in your Wave

using the remote. Your Wave

using the remote control. Just aim the remote at the front

panel and press the necessary buttons.

1. Press and hold down either Time button for

about 1 sec.

radio

Initially, HOLD_TO_SET appears on the display and

then quickly changes to – CLOCK SET – as the

button is depressed.

2. Release the selected Time button.

3. Press Time – to adjust the displayed time backward

or press Time + to adjust the displayed time for-

ward until it matches the current time. You can also

press and hold for rapid adjustment.

4. Wait five seconds for the system to exit the clock

setup mode automatically.

Notes:

• To change the clock display from 12-hour (AM/PM) time

to 24-hour time, see "Changing the time format" on

page 16.

• If the Wave

outage or uplugging the unit to move it, all system

settings will be permanently retained. However, the clock

time will only be temporarily stored in backup memory for

up to 48 hours.

radio III, set the clock

radio III is easily operated

Note: Press-and-hold operations

require holding the button down for

about one second.

radio III loses power due to a power

radio III