ABSCO SHEDS ADGAZEBO63 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Perabotan Luar Ruangan ABSCO SHEDS ADGAZEBO63. ABSCO SHEDS ADGAZEBO63 14 halaman. Signature gazebo

ATTACH Z FLASHING

ROOF PANELS

REAR VIEW - Aligning the first panel

Rear beam

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO63

6.12m W x 3.11m D x 2.60m H

'Z' flashing

1. Place one Z flashing TR35 along the lower side

beam as pictured.

Align to be flush with the exterior of the beam.

2. Overhang the end of the beam by 125 mm.

3. Fasten flashing to top of beam with 4 evenly

spaced pop rivets FAST102.

4. Fasten the second Z flashing in the same

manner.

A. Check the foam core is flush with the top and

bottom skins. If it bulges out, safely trim flush with

a Stanley knife.

B. Check if the steel bottom skin corner is bent

down below the bottom face. Bend it up with

pliers.

C. To increase weather protection turn up the

pans 15 degrees with a turn up/down tool or

equivalent as shown. (Front end only)

Familiarize yourself with the weight and orientation

of the AD1 panel before lifting.

The panel end with 'top skin' overhang & sticker

must go to the low side beam.

The 'bottom skin' has a protective plastic coating,

this can be peeled off just before lifting.

Remember to lift and place do not slide, this can

scratch the panel.

1. Safely position the first panel on top of the

frame - all the way to the end shown.

The steel 'top skin' will sit over the rear flashing.

2. Adjust so it's butted up against the rear trim

and the side of the 'top skin' is flush with the end

of the flashing.

Model: ADGAZEBO63

4/12/23

1.00