ABSCO SHEDS SIGNATURE ADGAZEBO33 Buku Petunjuk - Halaman 11

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Perabotan Luar Ruangan ABSCO SHEDS SIGNATURE ADGAZEBO33. ABSCO SHEDS SIGNATURE ADGAZEBO33 14 halaman.

Halaman Cetak
GUTTERING
1
A
B
2
Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
4
1. Take a gutter end stop RWG25 and test fit it
over an end of the gutter. Mark off the following.
A. Midpoint along the top
B. Face of gutter shown
2. Trim away area shown in grey with tinsnips
Repeat steps at the other end to make the other
end stop.
3. At the rear of the structure, take an outside
measurement from the left to the right flashing.
Trim the gutter to match this length.
4. Attach end caps with a rivet FAST102 through
the front back and bottom. Joints may be sealed
using water proof sealant
5. Test fit the gutter assembly
• Side flashings go inside end caps.
• Roof panel 'top skin' sits under top face of
end caps.
• This face will be against the rear beam.
Model: ADGAZEBO33
21/09/23
1.00
11