Bose FreeSpace ZA 190-HZ Panduan Instalasi dan Pengoperasian - Halaman 30

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Penguat Bose FreeSpace ZA 190-HZ. Bose FreeSpace ZA 190-HZ 44 halaman. Rack mount kit for amplifiers
Juga untuk Bose FreeSpace ZA 190-HZ: Panduan Instalasi dan Pengoperasian (22 halaman), Panduan Memulai Cepat (2 halaman)

Bose FreeSpace ZA 190-HZ Panduan Instalasi dan Pengoperasian
Installation

Installation and Placement

Importance of proper ventilation

For placement of the amplifier, keep the following in mind:
• Make sure that air can circulate freely around the amplifier for adequate ventilation� There are vents on the top, bottom,
and sides�
• Do not cover or block amplifier vents�
• Do not enclose amplifier in a small space, such as a cabinet�
• Make sure the chassis is protected from heat and kept away from direct heat sources, such as heating vents and
radiators�
caution: Do not allow the chassis to exceed the maximum operating temperature of 40° C (104° F)� Be aware of condi-
tions in an enclosed rack that may increase the temperature above room-ambient conditions�
Note: If the amplifier becomes too hot, it will go into a thermal protection mode and mute all outputs�

Placing on a flat surface

The amplifier can be placed on a flat, stable surface like a table, counter, or shelf� Plastic feet are included with the
amplifier to protect the surface area, prevent the chassis from sliding, and allow heat to escape from the bottom vent�
Note: The included feet shall always be used when placing amplifier on a flat surface to ensure proper ventilation�

Installing the feet on the amplifier

The included feet are comprised of two parts: a foot and a pin�
1� Place the amplifier upside-down on a flat, level surface on a protective covering to avoid scratching the top of the
chassis�
2� Insert the four feet into the four holes on the bottom of the chassis�
3� Insert a pin into the hole on the foot�
4� Press down on the pin until the foot locks into place� Repeat for all four feet�

Stacking units

One amplifier can be stacked on top of another when there is limited space available on a table, counter, or shelf�
Note: The included feet always shall be used on both amplifiers when stacking them to ensure proper ventilation�
Page 30
Installation and Operation
pro.Bose.com
English