Beckett 7575A0000 Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Pengontrol Beckett 7575A0000. Beckett 7575A0000 12 halaman. 120v advanced burner control
Halaman Cetak
Can cause severe injury, death, or
property damage.
•
Avoid prolonged exposure to water
•
Never install the control where water will
regularly flood or drip on the control.
•
If the control is ever placed under water,
replace it.
Electrical shock can cause severe
personal injury or death.
•
Disconnect ALL electrical power to the
appliance/burner circuit before installing or
servicing this control.
•
Provide ground wiring to the appliance,
burner and metal control mounting box.
•
Perform all wiring in compliance with the
National Electrical Code ANSI/NFPA 70
(Canada CSA C22.1).
All heating appliances must have
HIGH LIMIT protection to interrupt
electrical power and shutdown the
burner if operating or safety controls fail and
cause a runaway condition.
•
Follow the appliance manufacturer's wiring
diagrams and note all required safety
controls.
•
Typical safety controls include high
temperature or pressure limits, low water
cutoffs, pressure relief valves and blocked
flue sensing switches.
•
Verify all limit and safety controls are installed
and functioning correctly, as specified by the
manufacturer, applicable safety standards,
codes and all authorities having jurisdiction.
•
Ensure that the appliance is free of oil and oil
vapor before starting or resetting the burner.
6
Fire or Explosion
Hazard
Electrical Shock
Hazard
Explosion, Fire,
Scald, and Burn
Hazard
Improper Control Operation
•
GeniSys wiring label colors may not match
the wire colors of the burner or other
manufacturers' controls.
•
The GeniSys Control should be wired
according to the appliance manufacturer's
instructions.
Mounting:
◦
Mount the control on a 4" x 4" junction
box on the burner, or inside the
appliance cabinet. In replacement
applications, mount the new control in
the same location as the old control. In
some replacement applications, it may
be necessary to rotate the control on
the 4" x 4" box for best fit.
◦
Mounting orientation: any orientation is
acceptable.
Wiring:
◦
Make sure all appliance wiring complies
with all local codes and ordinances.
◦
Make connections to the control's
terminals as shown in Figures 2 & 3.
Refer to the label on the underside of
the control for wiring details.
Incorrect Wiring
Will Result in