Elegoo MARS 4 Series Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer 3D Elegoo MARS 4 Series. Elegoo MARS 4 Series 20 halaman.
Juga untuk Elegoo MARS 4 Series: Panduan Pengguna (20 halaman)
Halaman Cetak
Test Printing
1. Model Printing
Install the resin tank back in place and
tighten the screw knobs. Wear a mask
and gloves (avoid direct contact of resin
with your skin), then slowly add resin
to the MAX line of the resin tank. Plug
the USB air purifier into the USB port
with the front side facing outwards,
(the green light is on during printing,
indicating that the air purifier is in
normal working condition). Cover the
anti-UV cover and make sure the printer
is level and not wobble. Insert the U disk
into the printer, select the model file
"test model.goo"
(See Picture 9)
and start printing.
If you find that there is not enough resin in the resin tank to complete the model
printing, you can press the "pause" button, add more resin to the resin tank after
the build platform stops lifting, and then press "Print" to continue printing.
Pre-sliced Test Model.goo
打印
Install the resin tank back in
place and tighten the screw knobs.
Pre-sliced Test Model.goo
（Picture 9）