anko LD-K1046A Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Ketel anko LD-K1046A. anko LD-K1046A 7 halaman.
Halaman CetakAfter the water is boiling, the kettle switches OFF automatically and the lamp will go out.
8. If you wish to stop heating the water before it boils, turn the On/Off switch to Off (0) position.
WARNING: Risk of scalding from hot water
* Be sure that the water kettle is switched OFF before taking it off the power base.
9. After the water has come to a boil, wait a moment until the water has stopped simmering.
Then remove the kettle from the water base.
10. Pour the water out slowly to avoid splashing. Do not open the lid while pouring out the water.
* The sieve insert in the spout prevents any larger particles of scale being poured out.
* Do not re-boil stale water. Pour it away and refill with fresh water for boiling.
DANGER– risk of electric shock
* Remove the mains plug from the wall socket before cleaning the kettle.
* The power base, plug and mains cord must not come into contact with water or other liquids.
* The water container must not be immersed in water.
* The product and its parts must not be cleaned in the dishwasher.
IMPORTANT! Damage to exterior
* Do not use caustic, aggressive or abrasive cleaning products for cleaning the kettle exterior.
Cleaning
1. Remove the mains plug from the socket and let the water kettle cool down completely.
2. Wipe the base and power cord with a dry cloth.
3. Wipe the outside of the jug with a slightly moistened cloth.
4. Pull the sieve out of the spout.
5. Rinse it under running hot water.
6. Slide the sieve into the spout as far as it will go.
Descaling
IMPORTANT! During the below process, DO NOT fill the kettle more than the Min water level mark (0.5L)
on the kettle. Filling above the Min. water level mark will cause overboiling and spillage out of the spout.
The kettle must be descaled at regular intervals, especially if the power base is visibly encrusted
with lime scale. Regular descaling saves energy and increases the service life of the kettle.
For ecological reasons, we recommend using a three-to-one (3:1) solution of water and vinegar
or citric acid to descale the kettle.
Note: we recommend preparing in the mixture in a separate container and then pouring into the kettle.
1. Let the solution soak in the kettle for about an hour, and then bring it to the boil.
2. Thoroughly rinse out the kettle with fresh water.
Alternatively, you may use commercially available kettle cleaning solutions. Please follow the instructions
provided with the cleaning solution.