anko WK8359AE Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Ketel anko WK8359AE. anko WK8359AE 6 halaman. Cordless water kettle

Before first use

Before first use, it is recommended to operate the kettle for

2 or 3 times following the instructions below, this will

remove any dust or residues remaining from the

manufacturing process.

· Remove kettle from the power base before filling.

· To fill the kettle, open the top lid by pulling on the lid

handle, then fill the kettle with cold water (note: the water

level must be between the minimum mark, 0.5L and

maximum mark, 1.7L). Close the lid by pushing it down

until it clicks into place.

· Connect the power supply cord plug into a mains power

outlet socket. Press down on the ON/OFF switch, and the

power indicator will light up.

· When the water has boiled, the kettle will automatically

switch itself OFF. You can stop the boiling process at any

time by lifting the ON/OFF switch. The power indicator light

will go out.

Cleaning

· First read the instructions in the section titled

"IMPO RTANT INSTRUCTIONS".

· Always disconnect the kettle from the mains power outlet

socket before cleaning.

· Before cleaning make sure the kettle is cool to touch.

· Empty the kettle. Clean the exterior surface of the kettle

with a clean, damp cloth to preserve its original polished

finish. Dry and polish with a soft cloth.

· Do not use abrasive cleansers or scouring agents/pads

of any kind inside or on the exterior of the kettle.

· Open the lid, lift out the filter, rinse the filter under warm

water and brush off any impurities.

· Refit the filter and lid in reverse order.

· Only use a dry cloth to wipe the base of the kettle.

· Avoid wetting the electrical parts.

· Do not immerse the kettle or power base in water or other

liquid, and make sure the electrical parts are kept dry.