anko WHL-106 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyedot Debu anko WHL-106. anko WHL-106 10 halaman. Window vacuum cleaner

CLEANING AND STORAGE

Cleaning the device

Turn the device off.

Lift the water tank cap, remove the filter and empty the water tank by turning the device upside down

above the sink.

Clean the device and accessories with a damp cloth and a mild detergent and allow to dry completely.

Wash the filter carefully before placing it back in the unit. The collected water from the vacuum cleaner is

recycled though this filter and it is therefore important that the filter is cleaned after each use.

Note: Never use abrasives, bleaching agents or steel wool to clean the device. This could cause damage to

the product.

Rinsing the water tank

To clean the water tank, we recommend that you fill it with water, close the lid and shake the unit vigorously.

This will release any lime-scale deposits that have collected on the bottom of the tank. Pour the water out by

holding the cleaner upside down.

Lime-scale removal

To extend the life of your device, it is recommended to descale the appliance every six months. Switch the

device off and remove the charger from the socket. Fill the tank with 130ml of 50℃ hot water and add one or

two descaling tablets or solution (commercially available kettle cleaning solution can be used for this

purpose). Pour the water out as described above after 30 minutes.

Storage

Make sure that the device and the attachments are completely clean and dry before you store the device.

Window Cleaner Input

Battery Charger Input

Battery Charger Output

Li-ion Battery Pack

5Vd.c. 1000mA

100-240V~ 50/60Hz 0.2A

5Vd.c. 1000mA

ICR18650P-1500mAh, 3.7Vd.c. 1500mAh