anko 404201 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Blender anko 404201. anko 404201 15 halaman. Vacuum blender

4. Press down the Upper Cover and make sure the Filter cap lock/release paddle hooks

the vacuum valve of the lid so that the switch on the cap can be activated. You will hear

a click sound once it is placed and closed correctly.

5. Connect the supply cord into a mains power outlet socket. Turn the rotary selector to

ON, the appliance will enter the standby mode with program indicator lights (on, ice,

v-blend, vacuum will light up) to indicate that the appliance is ready for use. You can

then choose the preferred functions.

Using the functions

Ice:

The ice function on the blender is programmed to crush the ice. Use ice cubes approx. 2cm

x 2cm x 2cm in size, remove the blending jar lid and place the ice cubes not more than

200g into the jar. Press the "ice" button to start ice crushing function.

NOTE: for best results add a bit of water when crushing ice.

Please note:

During this function, the motor works for 1 minute for the entire cycle.

Pressing the ICE button again or setting the rotary switch to OFF will cancel this

function.

When the program is finished, you will hear 1 beep and all 4 indicator lights will be ON.

Pull up the Filter Cap Lock/Release Paddle to open the Upper Cover and rotate the

blending jar anticlockwise to remove from the jar from the base.

Do not blend dry ingredients (for example pepper corn or star anise).

Do not blend without any contents in the blending jar. This can damage the electric

motor in the blender.

V Blend

Press the "v blend" button, the vacuum blender will vacuum first and then blend for 1

minute before stopping.

Please note:

When the vacuum level of the jar reaches to the standard preset value, the vacuum

pump will stop automatically. You will hear 1 beep sound and then it will automatically

enter into blending procedure. After 1minute of blending, the blender will stop

automatically and go into the standby mode and all 4 indicator lights will be on.

Set the rotary program to OFF, pull up the Filter Cap Lock/Release Paddle to open the

Upper Cover and rotate the blending jar anticlockwise to remove the jar from the base.

When removing the jar lid, press the air release button on the top of the jar lid to

release the suction pressure (until no air flow sound). This will allow sufficient air into

the jar allowing easy removal of the jar lid.