anko HB956SH6PA Petunjuk Manual - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Blender anko HB956SH6PA. anko HB956SH6PA 10 halaman. Hand-held blender

How to use the chopper

. Remove the protective cover from the blade on the chopper.

. Clean the lid, blade unit and the chopper bowl.

. Fix the blade unit in the chopper bowl.

. Fill the food/ingredients to the bowl (not more than the maximum indicated level).

. Fit the power handle inside the chopper, turn it clockwise and lock it until you hear a slight click.

NOTE: The marks on the power handle and blender shaft should be aligned with each other. If it is

aligned, the blender shaft is locked correctly.

. Check the chopper and power cord for any damages.

. Make sure your electricity supply is the same as the one shown on the product rating label.

. Connect the appliance into a mains power outlet, adjust the desired speed setting, hold the power

handle steady. Switch the appliance ON by pressing on the switch button.

. After blending, release the switch button then disconnect the blender from mains power outlet.

WARNING: To prevent damage to the electric motor, the continuous operating time

must be less than 30 seconds. Allow the appliance to rest at least 2 minutes between 2

running cycles. After operating 3 continuous cycles, allow the appliance to cool down for 30

minutes before using it again.

Never chop hot oil, fat.

. If the blender gets blocked, first stop and disconnect the blender from mains power before

clearing.

. After use, always disconnect from mains power outlet and remove power handle and the lid unit in

sequence, take the blade out of the bowl by holding the plastic shaft, then pour out the food.

. The edges of the blade is very sharp, do not touch them.

. Always switch OFF and unplug from mains power before cleaning. Please refer to "care and

cleaning" instructions section in this manual

To use the whisk

. Clean the whisk and beaker.

. Insert the whisk into the whisk head until you hear a slight click.

. Fit the power handle inside the whisk, turn and lock until you hear a slight click. The marks on the

power handle and the whisk head should now be aligned with each other. If this is the case, the

whisk is locked correctly.

. Check the whisk and power cord for any damages. DO NOT use if damaged.

. Make sure your electricity supply is the same as the one shown on the product rating label.

. Fill the food/ingredients to the beaker (not more than the maximum indicated level) to hold the food

for whisking.

. Connect the appliance into a mains power outlet socket, adjust the desired speed setting, hold the

power handle steady. Switch the appliance ON by pressing the switch button.