Ankom Daisy D200 Penggantian - Halaman 2

Jelajahi secara online atau unduh pdf Penggantian untuk Aksesori Ankom Daisy D200. Ankom Daisy D200 4 halaman. Motor replacement

Remove the two drive belts.

a. Open the Daisy cabinet door.

b. Remove the top drive belt from the top drive roller and center

drive pulley.

c. Remove the bottom drive belt from the bottom drive roller

and drive pulley.

Remove the drive pulley.

a. Loosen the hex screw on the inside of the drive pulley using a

3/32 hex wrench.

b. Remove the drive pulley from the shaft and set it aside for

later.

Locate and remove the three motor mounting screws.

Use two technicians for this step and the following step.

Technician #1 will be located in the back of the instrument and

Technician #2 will be located in the front of the instrument.

a. Locate the motor mounting screws by pressing through the

insulation with your finger (marked by three X's in the image

to the right). You will feel a rounded screw head. Use a

Phillips screwdriver to push through the insulation.

b. Technician #1 holds the motor on the back of the instrument to

support and remove it after the screws have been taken out.

c. Technician #2 unscrews the three screws on the front inside of

the cabinet, using a Phillips screwdriver. Set the old motor and

three screws aside.

ANKOM Technology  2052 O'Neil Road  Email: [email protected]  Phone: 315-986-8090  Fax: 315-986-8091

Motor Replacement

D200/D200I

Service Procedure

Revised: 08/06/2014

Top

Drive

Roller

Drive

Pulley

Bottom

Drive

Roller

Hex screw inside drive pulley

Drive Roller

001

Drive

Belts

Drive

Pulley

pg. 2 of 4