Ankom XT10 Pembersihan - Halaman 3

Jelajahi secara online atau unduh pdf Pembersihan untuk Scrubber Ankom XT10. Ankom XT10 4 halaman. Solvent filter

Clean the Solvent Filter Element thoroughly.

a. Blow air through the element to remove particles.

b. If blowing air does NOT fully clean the element, wash it in hot soapy water. Rinse the element

thoroughly and dry it before re-installing.

c. Replace the element if it is damaged or cannot be cleaned.

Re-install the Solvent Filter Element.

a. Re-install the Solvent Filter Element.

b. Re-install the filter body.

c. If the fitting on the body installs past vertical it's

time to replace the PTFE washer (see the

procedure on the next page).

Correct Installation

ANKOM Technology • 2052 O'Neil Road • Email: [email protected] • Phone: 315-986-8090 • Fax: 315-986-8091

Solvent filter cleaning

XT10/XT10I and XT15/XT15I

Service Procedure

Incorrect Installation

XTS016

JAD 1/19/2018

pg. 3 of 4