Anlinx PT7003 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Terminal sentuh Anlinx PT7003. Anlinx PT7003 7 halaman.

reasonable protection against harmful interference in aresidential installation. This

equipment generates, uses and can radiate radiofrequency energy and, if not installed and

used in accordance with theinstructions, may cause harmful interference to radio

communications. However,there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

‐‐ Reorient or relocate the receiving antenna.

‐‐ Increase the separation between the equipment and receiver.

‐‐ Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

‐‐ Consult the dealer or an experienced radio/TV technician forhelp.

Specific Absorption Rate (SAR) information:

This Mobile Phone meets the government's requirements for exposure to radio waves. The

guidelines are based on standards that were developed by independent scientific

organizations through periodic and thorough evaluation of scientific studies. The standards

include a substantial safety margin designed to assure the safety of all persons regardless of

age or health.

FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 4.0 W/kg averaged

over one gram of tissue. Device types: PT7003 (FCC ID: 2AJJYPT7003) has also been tested

against this SAR limit. The highest SAR value reported under this standard during product

certification for properly extremity is 1.577W/kg. The use of belt

clips, holsters and similar accessories should not containmetallic components in its assembly.

The use of accessories that do not satisfy these requirements may not comply with FCC RF

exposure requirements, and should be avoided.

extremity Operation

This device was tested for typical body‐worn operations. To comply with RF exposure

requirements, a minimum separation distance of 0cm must be maintained between the

user's body and the handset, including the antenna. Third‐party belt‐clips, holsters, and

similar accessories used by this device should not contain any metallic components.

Body‐worn accessories that do not meet these requirements may not comply with RF

exposure requirements and should be avoided. Use only the supplied or an approved

antenna.

FCC ID: 2AJJYPT7003