3M 725 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur 3M 725. 3M 725 16 halaman. Wrist strap monitor
Juga untuk 3M 725: Petunjuk Manual (15 halaman)
Halaman Cetak
SECTION 5
Installation Using 3M
Belt Clip 723 (Optional)
™
An optional belt clip is available to further enhance the portability feature of
the 3M
Wrist Strap Monitor Model 725. This expands the use of the monitor
™
when operators need to be highly mobile as in an electronic manufacturing
environment. Simply attach the belt clip with female snap connector to the
male snap connector on the monitor bottom cover. Slide the clip over your
belt in a convenient place, so that the wrist strap ground cord will not interfere
with normal body movements when attached to the monitor. Attach the dual
conductor ground clip to a suitable ground at the work location. During mobility,
attach the dual conductor ground clip to the parking clip on the Wrist Strap
Monitor Model 725 (See Section 6).
SECTION 6
Parking Clip
A parking clip is supplied
with the Wrist Strap Monitor
Model 725 allowing mobile
users to silence the ground clip
disconnect alarm. Attaching the
dual conductor ground clip to the
parking clip prevents unnecessary
disconnecting/connecting of the
wrist strap ground cord from the
input jack during mobility. An
Figure 5
added benefit of this feature is that
it extends the life of the dual conductor ground cord plug and the monitor's input
jack. The parking clip is already attached to the mounting tab of the Wrist Strap
Monitor Model 725. If the Wrist Strap Monitor Model 725 is to be mounted
under a work bench for permanent use, remove the parking clip from the Wrist
Strap Monitor Model 725 using a small screwdriver.
9