Absocold Corp AFD502MW11R Petunjuk Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Pemilik untuk Pembeku Absocold Corp AFD502MW11R. Absocold Corp AFD502MW11R 2 halaman. Absocold corp freezer user manual

Halaman Cetak
THINGS YOU OUGHT TO KNOW
WHEN YOUR FREEZER IS INSTALLED
INSPECT
Inspect for shipping damage. If damaged or parts are missing, notify your Absocold dealer at once.

INSTALLATION REQUIREMENTS

Remove all packing material and tape. Install on a level floor or well-supported counter. Avoid any direct sunlight, heat source, or moisture. This freezer is
designed to be
freestanding
— that is, the appliance is to be installed at least 1-½" from the wall and the cabinet bottom is at least ¾" to 1" above the floor or
recessed
carpet. If this appliance is

ELECTRICAL REQUIREMENTS

120 volts, 60 Hz.
ELECTRICAL GROUNDING
(
for 120-volt models only)
Must be grounded. Uses 110-120 volts, 60 Hz (60 cycles A.C.) Do not use extension cord. Use three-prong plug, with three-prong grounded wall outlet.
Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical
component or wiring of freezer.
CAUTION
Should you unplug freezer, allow at least three minutes before restarting in order to allow the start relay to function properly.
USE AND CARE INFORMATION
•
TIPS ON EVERYDAY USE AND CARE
TEMPERATURE CONTROL
:
The freezer temperature can be adjusted by the Cold Control Knob. Freezer temperature will become lower as the control knob is set closer to the
position. Freezer temperature will vary depending on the quantity of food stored and the frequency with which the door is opened. Ice cream can be used
as an indicator of freezer temperature. If it is too hard or too soft, adjust the Cold Control Knob accordingly.
HOW TO DEFROST
:
Remove contents from freezer. Keep drip tray in place. Set Cold Control knob to OFF position.
Defrosting may take up to several hours. To defrost faster:
* Leave door open
* Place pans of hot water on frosted shelves.
NEVER USE A KNIFE OR METAL OBJECT TO REMOVE FROST OR ICE, AS THIS MAY SEVERELY DAMAGE THE REFRIGERATION SYSTEM.
When defrosting is complete, remove drip tray and dispose of water. Set Cold Control back to original position.
FOR ALL CLEANING
: Mix 2 tablespoons baking soda or 2 tablespoons of mild soap with 1 quart warm water. No strong cleaners, scouring powder or
pads should be used. Do not put the defrost tray in dishwasher.
•
THINGS TO REMEMBER:
Allow 24 hours for your freezer to reach a new temperature setting.
1.
The motor will start and stop often. It must do so in order to maintain the temperature you select.
2.
Keep your freezer reasonably level.
3.
Unplug freezer before doing anything with the electrical system.
4.
•
BEFORE CALLING FOR SERVICE
Read all Use & Care Information, as your questions may be answered. If not, find your model number (on upper back of freezer). Refer your model
number and serial number to Absocold Corporation at (800) 843-3714 or (765) 935-7501.
FREEZER IS TOO WARM: Adjust Cold Control. Make sure door is closed properly.
MOISTURE COLLECTS ON THE OUTSIDE: Frequent door opening in highly humid conditions will cause this. Reduce door openings and reduce time
door is open. Make sure door seal is tight.
FREEZER IS NOISY: Make sure cabinet is level, and not touching a wall or other surface. Make sure condenser coils are free of lint and dust. Normal
noises include refrigerant gurgling as it passes through tubes and the compressor clicking on and off.
DANGER—ELECTRICAL SHOCK HAZARD. Disconnect power before servicing.
ENERGY SAVING TIPS -
•
Reduce door openings.
•
Close the door as soon as you can.
•
Adjust temperature control to warmer setting when practical.
WARNING!
•
Your freezer should be connected directly to a grounded electrical wall outlet.
No extension cords, multi-connection bars, etc. should be used.
•
In case of prolonged power outage or an electrical disconnect of any type, please check your freezer for spoiled food.
built-in
,
or otherwise enclosed to restrict airflow, then all warranties stated herein are null and void.
WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR FREEZER
* Wipe with warm towel or sponge
•
Don't allow more than 1/4" of frost to build up on evaporator coils.
•
Keep your freezer away from stoves or other heat sources.
MAX