DryBell Vibe Machine V-2 Manual Opsi - Halaman 4

Jelajahi secara online atau unduh pdf Manual Opsi untuk Pedal Musik DryBell Vibe Machine V-2. DryBell Vibe Machine V-2 18 halaman.
Juga untuk DryBell Vibe Machine V-2: Panduan Pengguna (2 halaman)

Halaman Cetak

DryBell Guitar Effects

3 SPEED POTENTIOMETER MARKS

Ok, let's get started! . In the pedal's normal operation mode when nothing is connected to the PEDAL+ expression

jack the Speed potentiometer will only adjust speed. The Speed potentiometer has setting labels marked around it; E1, E2,

E3, S4, S5, S6, X7, T8, T9 and T10. All positions are utility positions but only positions T8, T9 and T10 (used for Tap Tempo

multipliers) can be changed on the fly while using an external footswitch or expression pedal.

All positions E1, E2, E3, S4, S5, S6, X7, T8, T9, T10 are general utility positions for setting the 'set and forget'

parameters of the V-2 pedal, using two available utility modes: PEDAL+ mode and general SETUP mode, which will be

described later.

The name of each position is pretty logical. E positions are for setting the Expression pedal modes, S positions are for

setting external Switch (footswitch) modes and T positions are for choosing Tap Tempo multipliers on the fly. X7 is the

position used for utility modes and for maximum speed settings (or Leslie delay) when the pedal is operated in E2, E3 or S5

mode.

EXTERNAL FOOTSWITCH MODES,

SETUP MODE LABELS

EXPRESSION PEDAL MODES,

SETUP MODE LABELS

4 PEDAL+ JACK MODE AND SETUP MODE FUNCTIONS

The Vibe Machine V-2 has two different types of utility modes: the PEDAL+ jack modes

modes

(Page

8). All these modes, described in detail later in this manual, are 'set and forget' features of the Vibe Machine

V-2.

When the user selects the PEDAL+ jack mode, the user defines whether an expression pedal or external footswitch is

connected to the PEDAL+ expression jack, and for which features this connected hardware will be used (external speed

control, Cancel mode, Tap Tempo mode, Fast/slow mode or Two speed mode).

With SETUP modes

V-2 hardware/firmware structure.

When we developed these modes we also embedded a Reset to Default Factory Settings Function

V-2 system. This function resets all V-2 firmware settings to our factory settings, which we are pretty sure are the best

combination of settings for most guitarists and pedalboard builders.

BACK TO CONTENTS

www.drybell.com

Figure 1. Speed potentiometer label

MIN

(Table 2, Page

9) the user defines additional secondary settings and features embedded into the

DryBell

Vibe Machine V-2, Options User's manual, rev.1.4. 09/2018

T10

MAX

NO PEDAL+ FUNCTION,

SETUP MODE LABEL,

SEE CHAPTERS 5.3, 5.4, 5.6

TAP TEMPO MULTIPLIERS,

SETUP MODE LABELS

(Page

5) and general SETUP

(Page

12) into the

Doc. No. DM0958/ Page 4