Anolis arcpower smartwhite 72 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perlengkapan Lampu Anolis arcpower smartwhite 72. Anolis arcpower smartwhite 72 20 halaman.

Halaman Cetak

2.RJ45 patch cables category 5 that connect the ArcPower SmartWhite 72 each other are wired 1:1,that is,pins

with the same numbers are connected together.

Pin 1: Not used

Pin 2: Not used

Pin 3: Not used

Pin 4: Not used

Pin 5: Not used

Pin 6: Data +

Pin 7: Data -

Pin 8: GND

5.Installing instructions.

5.1.DMX operating

1.Unplug from the mains before installation.

2.Connect the LED modules to the fixture.

3.Connect the DMX controller to the fixture

4.Connect the fixture to the mains

5.Set the DMX address on the control board of the fixture (see chapter "Control board").

Accidental connection DMX 512 Input/Output to non-DMX 512 device (e.g.Ethernet

network Hub) can damage the ArcPower SmartWhite 72.

Maximum total cable length between one LED zone output of the ArcPower

SmartWhite 72 and all its connected LED modules is 80 metres.

Single ArcPower SmartWhite 72 installation:

Multiple ArcPower SmartWhite 72 installation:

Connect the DMX output of the first ArcPower SmartWhite 72 with the DMX input of the next ArcPower Smart-

White 72. Always connect one output with the input of the next ArcPower SmartWhite 72 until all fixtures are

connected.In this way,up to 32 fixtures can be chained together.

At the last ArcPower SmartWhite 72 the data link has to be terminated with a terminator. A termination plug is

simply a RJ45 connector with a 120

output of the last ArcPower SmartWhite 72.

Maximum number of LEDs connected to the one zone of the ArcPower SmartWhite 72 is 36.

Warning!

resistor between pins Data (–) and Data (+).Plug terminator in the DMX