Daikin R32 Split Series Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kipas angin Daikin R32 Split Series. Daikin R32 Split Series 17 halaman. R32 split series
Juga untuk Daikin R32 Split Series: Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (17 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (14 halaman), Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (16 halaman), Panduan Pengoperasian (8 halaman), Panduan Instalasi (17 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (17 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (13 halaman)

Halaman Cetak

Daikin R32 Split Series Panduan Instalasi

Preparation before Installation

Removing and installing front panel

• Removal method

1) Place your fingers in the indentations on the main unit (one each on the

left and right sides), and open the front panel until it stops.

2) Continue to open the front panel further while sliding the panel to the

right and pulling it toward you in order to disengage the front panel shaft

on the left side. To disengage the front panel shaft on the right side, slide

the panel to the left while pulling it toward you.

• Installation method

Align the tabs of the front panel with the grooves, and push all the way in.

Then close slowly. Push the centre of the lower surface panel firmly to

engage the tabs.

Removing and installing the front grille

• Removal method

1) Remove the front panel to remove the air filter.

2) Remove the 2 screws from the front grille.

3) In front of the

Lightly pull the front grille toward you with one hand, and push down on

the hooks with the fingers of your other hand.

When there is no work space because the unit is close to ceiling

CAUTION

• Be sure to wear protection gloves.

Place both hands under the centre of the front grille, and while pushing up, pull it toward you.

• Installation method

1) Install the front grille and firmly engage the upper hooks (3 locations).

2) Install 2 screws of the front grille.

3) Install the air filter and then mount the front panel.

How to set the different addresses

When two indoor units are installed in one room, the two wireless remote controllers

can be set for different addresses.

1) In the same way as when connecting to an HA system, remove the metal plate

electrical wiring cover.

2) Cut the address jumper (JA) on the printed circuit board.

3) Cut the address jumper (J4) in the remote controller.

English

mark of the front grille, there are 3 upper hooks.

Rotating shaft

Push the rotating

shaft of the front

panel into the groove.

mark area

Upper hook

(3 locations)

Upper hook

Push

down.

1) Push up.

2) Pull toward you.

Jumper