DRYSPEC H35 Lid Rigid MOLLE Buku Petunjuk

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Sepeda DRYSPEC H35 Lid Rigid MOLLE. DRYSPEC H35 Lid Rigid MOLLE 2 halaman. H35 lid rigid molle panel kit

Halaman Cetak

Instruction Manual

H35 Lid Rigid MOLLE Panel Kit

DSL.H35.10200

What's In The Box?

Kit Contents

(a) Rigid Lid MOLLE Panel..........................................................Qty 1

(b) No. 6 x 3/8" Thread Forming Screw......................................Qty 4

Instruction Rev01

Thank you for choosing DrySpec

We know you would rather be riding your bike than wrenching on it, so we go the extra

mile to make sure our instructions are clear and as easy to understand as possible. If

you have any questions, comments, or suggestions don't hesitate to give our gear

experts a call at 401.360.2551 or visit WWW.DRYSPEC.COM

Please Read Before Installing

DRYSPEC products should always be installed by a qualified motorcycle technician. If

you are unsure of your ability to properly install a product, please have the product

installed by your local motorcycle dealer. DENALI takes no responsibility for damages

caused by improper installation. Caution: When installing electronics it is extremely

important to pay close attention to how wires are routed, especially when mounting

products to the front fender, front forks, or fairing of your motorcycle. Always be sure

to turn the handlebars fully left, fully right, and fully compress the suspension to

ensure the wires will not bind and have enough slack for your motorcycle to operate

properly.

Installation Tips

We strongly recommend using medium strength liquid thread locker on all screws,

nuts, and bolts. It is also important to ensure that all hardware is tightened to the

proper torque specifications as listed in your owner's manual. For included accessory

hardware please refer to the default torque specifications provided below. Inspect all

hardware after the first 30 miles to ensure proper torque specifications are

maintained.

Bolt Size

in-lbs

10.0 in-lbs

23.0 in-lbs

44.5 in-lbs

78.0 in-lbs

M10

M12

Hardware Sizing Guide

Not sure what size bolt you have? Use this ruler to measure screws, bolts, spacers, etc.

Remember, the length of a screw or bolt is measured from the start of the "mounting

surface" to the end of the screw, so only include the screw head when measuring

countersunk screws.

(a)

(b)

DRYSPEC.COM

ft-lbs

1.0 Nm

2.5 Nm

3.5 ft-lbs

5.0 Nm

6.5 ft-lbs

9.0 Nm

13.5 ft-lbs

18.0 Nm

30.0 ft-lbs

41.0 Nm

52.0 ft-lbs

71.0 Nm