DRYWISE 600591440003 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer 3D DRYWISE 600591440003. DRYWISE 600591440003 14 halaman. Pre-heater add-on for drywise dryer

Halaman Cetak

Safety

This guide contains warnings and safety notices:

Provides helpful information to do a task or avoid problems.

Warns against situations that may cause material damage or injury if

the safety instructions are not followed.

2.1.

General safety information

• Read and understand safety measures before use of the Product.

• Use the product for intended purpose only

• Use the product with caution. The internal components of the product generate

high temperatures that can cause injury. Do not dismantle and reach inside

the product. Allow at least 30 minutes for the product to cool down, before

performing any maintenance or modification.

• Do not modify or change any parts of the product unless the change or

modification is authorised by the manufacturer or this manual.

• Follow standard electrical safety procedures.

• Follow instructions and safety indicators on the screen of the dryer and/or follow

safety warning labels on the product components.

• Install the product to the Drywise drier well. When the device is connected to the

3D printer via filament, the forces of the extruder may pull the device.

• Do not manually pull or push on filament when the product is in operation unless

instructed by the dryer user interface.

• This product is not intended for children.

• Thought3D products (including Drywise Pre-Heater) are not intended for use by

persons with reduced physical and/or mental capabilities, or lack of experience

or knowledge, unless they are supervised or have been given instructions

concerning the use of the product by a person responsible for their safety.

• Do not insert any foreign objects other than filament for FDM/FFF 3D printing

into the pathway of the filament.

2.2.

Health and safety

• The product dries third party materials. Please follow the safety procedures of

the manufacturers of such materials

• The product operates with the help of third-party 3D printers. Please follow the

safety procedures of the manufacturers of such devices.

• Third party materials may release volatile organic compounds (VOCs) and/

or ultrafine particles (UFPs). It is recommended that the product is set-up in a

well-ventilated area. Please check the safety data sheet of each specific materi-

al for information.

• Thought3D Ltd cannot be held responsible for any adverse effects from the use

and/or performance of these materials.

Drywise Pre-Heater User Manual