DRYWISE 600591440004 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer 3D DRYWISE 600591440004. DRYWISE 600591440004 14 halaman. Pre-heater add-on for drywise dryer

Halaman Cetak

5.1.

The drying process (normal operation)

Operating the Drywise dryer device with the Drywise Pre-Heater add-on is no

different than when operating the device without the add-on installed.

Make sure the add-on is securely installed in place on the input port.

2. Select the preferred filament that you want to use.

3. Load the filament in the dryer, inserting the filament in the add-on entry point first.

4. Proceed with the normal drying process and printing routine. Refer to the Drywise

inline filament dryer operation manual if in doubt.

If the Drywise Pre-Heater add-on is installed, the Drywise inline filament dryer can

be used with it irrespective of the filament. The Drywise dryer will set the correct

parameters for the specific filament selected. If a filament needs the Pre-Heater add-

on and this is not installed the Drywise dryer will not allow you to choose said material

for drying until the add-on is installed.

Maintenance

6.1.

Recommendations

The Drywise Pre-Heater add-on does not need any specific or regular preventative

maintenance.

When opening the Pre-Heater add-on to replace the o-rings make sure it is reseated

correctly in place and that it is secured correctly with the thumbscrew.

Warning Message Screens

7.1.

Pre-Heater not detected

This screen will pop-up when a

specific material that requires the

add on has been selected for drying

and the system senses that:

•

The Pre-Heater add-on has not

been installed or

•

The Pre-Heater is not installed

correctly, or

•

The Pre-Heater is malfunctioning

If the add-on is installed correctly in

place, the thumbscrew holding it is

securely tightened but this warning

continues to be shown kindly

contact support.

Drywise Pre-Heater User Manual