DS Services of America 300m Series Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Dispenser Air DS Services of America 300m Series. DS Services of America 300m Series 7 halaman. Pure water dispenser

Halaman Cetak

TROUBLESHOOTING

WARNING:

Always turn off dispenser and unplug from power outlet before inspecting or starting any

maintenance.

WATER IS LEAKING

• The NO-SPILL bottle was loaded with the cap removed.

• Bottle may have a puncture or crack. Remove and install new bottle.

WATER DOES NOT FLOW FROM DISPENSER

• Make sure bottle is not empty; if empty, replace bottle.

• Inspect to see if there is a pinhole in the bottle; if so, replace bottle.

• Check valve on spill-proof dispenser insert; make sure it is allowing air into the reservoir.

• Remove bottle from dispenser. Dispense two cups of water. Place the bottle back on the dispenser.

WATER TASTES BAD

• Dispenser may need to be cleaned (see CLEANING AND SANITIZING).

WATER NOT HOT OR COLD ENOUGH

• Check to make sure dispenser is plugged in and the switch is turned on.

• A fuse may be blown or the circuit breaker may be tripped; if needed, replace fuse or reset breaker.

• Dispenser may be placed in direct sunlight or may be too close to a heat source; try moving dispenser into a cool shaded area.

• Check cold thermostat setting: turn ¼ clockwise for cooler water.

DISPENSER IS NOISY

• Make sure the dispenser is on a level floor strong enough to support it when fully loaded.

• It is normal for the bottle to make a gurgling noise as water fills the tank.

• It is normal for the dispenser or water bottle to shake when the cooling system cycles off.

• Some operating noise from the compressor and hot tank is normal.