DS Services of America pure water dispenser 200k Series Panduan Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Dispenser Air DS Services of America pure water dispenser 200k Series. DS Services of America pure water dispenser 200k Series 6 halaman. Diy: how to clean your water dispenser
Juga untuk DS Services of America pure water dispenser 200k Series: Cara Membersihkan (2 halaman)

Halaman Cetak
1
2
3

SAFETY PRECAUTIONS

Basic safety precautions should be followed when using electrical appliances, including:
• Only plug in dispenser in the sequence the manual indicates (see HOW TO INSTALL AND USE).
• In accordance with these instructions, the dispenser must be properly located and installed before use
(see HOW TO INSTALL AND USE).
• Use only bottled water in the dispenser.
• Keep all gasoline or other flammable vapors and liquids away from this and other appliances.
• Dispenser must be unplugged before cleaning, sanitizing or repairing (see CLEANING AND SANITIZING).
• Wipe up any water spills immediately after loading or unloading water bottles.
• Do not use with water that is microbiologically unsafe or of unknown quality.
• The dispenser heats water to a temperature above 190 º F (90 º C). Water temperatures above 125 º F (52 º C) can cause severe
burns or death from scalding. Most at risk of being scalded are children, the disabled and the elderly.
• Ensure the dispenser stands upright for 2 hours before loading water bottle, plugging in and turning unit on.
• Always lift dispenser by handle located on rear of unit. Lifting dispenser by faucet or faucet handles will damage the unit.
• Follow proper grounding safety precautions and instructions prior to plugging in the unit
(see GROUNDING SAFETY PRECAUTIONS AND INSTRUCTIONS).
• Supervise children when using the dispenser (see CHILD SAFETY).
GROUNDING SAFETY PRECAUTIONS AND INSTRUCTIONS
WARNING:
The dispenser must be grounded – if the appliance is improperly grounded, the result
could be electric shock.
Ensure that the available power supply matches the dispenser's voltage specifications indicated on the nameplate label
(located at the rear). Please ensure that dispenser is set up so access to the power outlet and plug is unobstructed.
IMPORTANT:
To provide additional protection from the risk of shock, the dispenser MUST be
connected to a ground fault circuit interrupter (GFCI) outlet at all times. Use of an extension
cord will void any warranties. See warranty document for complete terms and conditions.
®
2
Load water
bottle FIRST.
Dispense water
from hot and
cold faucets.
THEN turn on the
hot tank switch.
STOP & READ DIRECTIONS
STOP
before plugging in dispenser.
Read complete HOW TO INSTALL instruction sequence
before plugging in and turning on dispenser. Failure to
follow proper installation instructions may cause damage
to water dispenser.