DS Services of America Pure Water Dispenser 300m Series Cara Membersihkan

Jelajahi secara online atau unduh pdf Cara Membersihkan untuk Dispenser Air DS Services of America Pure Water Dispenser 300m Series. DS Services of America Pure Water Dispenser 300m Series 2 halaman. Pure water dispenser
Juga untuk DS Services of America Pure Water Dispenser 300m Series: Panduan Pengaturan Cepat (2 halaman)

Halaman Cetak
DIY: HOW TO CLEAN
YOUR WATER DISPENSER
Your water dispenser should be thoroughly cleaned at least twice a year. If your
dispenser hasn't been used in a while, we recommend
prior to cleaning. Here are instructions for do-it-yourself cleaning:
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
TIP:
The best time to clean your dispenser is when the existing water bottle is empty.
WHAT YOU'LL NEED:
• 70% rubbing alcohol or disinfecting wipes
• Squirt bottle filled with a small amount of
70% rubbing alcohol
• Dishwashing soap
• Clean cloth or soft brush
WARNING:
Always use caution when handling hot water.
1.
Turn off the hot tank heater switch on the back of the dispenser and unplug your unit (Fig 1).
Let the unit stand for one hour before cleaning to allow the hot tank to cool.
2.
Remove the water bottle and drain the water reservoir by dispensing water through the hot
and cold spigots.
3.
Clean the cabinet, bottle receptacle and spigots with 70% rubbing alcohol or disinfecting
wipes. Vacuum or wipe the grill on the back of the dispenser to remove any dust.
4.
Clean the drip tray and grill by emptying the tray and cleaning the tray and grill with
dishwashing soap or by placing them on the top rack of the dishwasher (Fig 2).
TIP:
The drip tray and grill should be cleaned monthly.
5.
Remove the no-spill dispenser insert.
(Note that the no-spill dispenser insert
is designed to fit tightly in the reservoir
and will require force to remove.)
– Begin by inserting a finger into the
notch in the dispenser insert and
prying up to reveal a gap (Fig 3a).
– Spray rubbing alcohol around the
no-spill insert and allow it to seep in
1-2 minutes to loosen the seal (Fig 3b).
– With a rocking motion, alternately lift
the front and the back of the insert
until the insert loosens and can be
removed (Fig 3c).
flushing
the equipment
• Disposable non-latex gloves
• Hot water (about a gallon)
• Heat-resistant container, like a metal pot
• Towels to absorb any water spills
Fig 3a
Fig 3b
TM
Fig 1
Fig 2
Fig 3c