DS18 FRX4K4 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat DS18 FRX4K4. DS18 FRX4K4 11 halaman.

BASS BOOST

DS18 FRX amps amplifiers

have an adjustable bass

boost. Begin your

adjustments at low

volume. If you do not hear

any improvement then

woofer does not

need any bass boost.

The Low Pass Filter (LPF)

must be switched on for

the bass boost to activate.

Use Bass Boost carefully. The demands on power output are tremendous. Try to

minimize the use by changing woofer position or the enclosure size.

This amplifier is a multi

channel amplifier

design, meaning it has

more than one channel

of speaker outputs. It is

equipped with a large

block style terminal for

speaker connection.

Make this connection

carefully and neatly.

Strip your wire back and

twist the exposed leads

and insert them into the block terminal while being careful that there is no loose or

frayed strands of wire and tighten the Allen head screw down on the terminal till

the wire is tightly secured in place. If the wires ever come in contact with each

other the amplifier will go into protection.

Before you start, disconnect the negative cable from the car battery.

Tape up the end so it is isolated from the battery.

Run an appropriate gauge wire from the battery to the amplifier. Plan this part

of the installation carefully. This cable will carry very high current, if it should

short to the body and it is not properly fused it could catch fire.

Connect the power wire to the battery using a fuse capable of the total current

load of all amplifiers connected. Don't install the fuse yet. Wait until the end.

Locate the fuse as close as possible to the battery. If the fuse is further than 18

inches (wire length) from the battery you should reevaluate the wire and fuse

placement.

Find the closest clear metal area to the amp for a ground. Sand, grind or

scrape all paint and undercoating from the body and screw the ground

securely in place.