DS18 BC60LP Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pengisi Daya Baterai DS18 BC60LP. DS18 BC60LP 6 halaman.

Step 1: Press MODE selector until AUTO SCI led turns on;

Step 2: Connect the Red (+) and Black ( )clamps on the battery poles

Step 3: The battery will be fully charged when the full charge led lights up.

Note: The Source can be constantly connected to the battery without any damage to it.

AUTO SCI MODE OPERATION DESCRIPTION

Mode when fast charging

output power

(14.4V)

are charged and are in pulsating float.

Step 1: Press MODE selector until POWER SUPPLY lights up

Step 2: Press VOLTAGE / BATTERY selector and choose charger output voltage from

the following values: 12.6V / 12.8V / 13.0V / 13.2V / 13.8V / 14.0V / 14.2V / 14 4V

Step 3: Connect the Red (+) and Black ( ) clamps to the equipment to be powered or

use the 12V socket for equipment with this connection.

Note:

When connecting an accessory such as the tire gauge, select 14.4V at the output to

get higher compressor power, and thus calibrate the tire faster

Note:

The battery must be discharged

Step 1: P

ress READ switch until VOLTAGE and CURRENT LEDs light simultaneously

Step 2:

If the display is not showing 000, hold down the READ switch until the display

shows 000

Step 3: Select SL

OW LOAD mode (3.1) and follow all steps described in this item.

Step 4 : When the full charge LED indicator lights up, the display will show the amount

of charge absorbed by the battery.

Exmaple: If the selected battery is 40A and the indicatonis 23A, then your batter has

accumulated 23 Ah, and this is the current capacity

STEP BY STEP AUTO ICS MODE

to the battery (s) is desired as it will maintain maximum

(Phase2)

and will enter the SCI pulsed system (Phase 3) when the battery (s)

STEP BY STEP POWER SUPPLY

BATTERY CHECK-UP