DSAN Limitimer PRO-2000 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengatur waktu DSAN Limitimer PRO-2000. DSAN Limitimer PRO-2000 14 halaman. Speaker timer system
Juga untuk DSAN Limitimer PRO-2000: Manual (5 halaman)
Halaman Cetak
Network Settings
When a PC is connected to the front USB port of Limitimer PRO-2000RM, a flash memory drive
"Limitimer" is enumerated and visible on Windows Explorer. Click on the application "Configure-
Networking ". (Windows® only.) A form appears that shows the network properties of the device.
The Network Mask determines what part of the IP address is the local area network.
This value should be obtained from your network administrator. Most consumer routers allow a
maximum of 255 IP addresses which are completely contained within the final octet of the router
address. Thus, the mask is usually "255.255.255.0."
An unused port number must also be obtained from the network administrator to send outside requests
to the PRO-2000RM to its assigned internal IP address.
©DSan Corporation
Make sure that Device "Limitimer" is selected
[A]. (This application is used for other DSan
products as well.)
By default, PRO-2000RM is set to be a "server"
[B] and use a dynamically assigned IP address.
DHCP is unchecked [C]. This is so it will not
disable other devices that may be connected to
your network that are assigned the same IP.
However, it is important for the server to have
a known IP address so that clients can be
configured to point to it. You can change to a
fixed IP address if you are running your own
network or if the network administrator
provides an unused IP address [B]. In this
context, Server is the Device IP Address.
If you are trying to establish a connection
outside of the local area network, you will need
to input the Gateway IP address. This is often
the address of the router itself. Quite
frequently, it is the first address in the range of
addresses that the router can assign to
connected devices. Many consumer routers
use 192.168.1.1 thru 192.168.1.255 as the
range of addresses. In this case, the gateway
address may be 192.168.1.1 and the connected
Limitimer Rackmount may be any other unused
addresses in that range.
Limitimer® Rackmount User Guide
7