Daintree DT108 Panduan Instalasi

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Daintree DT108. Daintree DT108 4 halaman. Wireless occupancy sensor, ceiling mount

Halaman Cetak

Daintree

Sensor, Ceiling Mount

(WOS2-CM)

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save these instructions for future use.

WARNING

Risk of electrical shock. Disconnect power before servicing or

installing product.

Install in accordance with National Electric Code and local codes.

The Ceiling Mounted Wireless Occupancy Sensor (WOS2-CM)

operates seamlessly within the Daintree Networked platform.

The WOS2-CM is a battery-powered occupancy sensor using

passive infrared (PIR) sensing technology to detect movement.

As part of the Daintree Networked platform and using open,

standards based ZigBee wireless communications, the WOS2-CM

reports real-time occupancy events to turn on lights or keep them

on when movement is detected, and turn off lights when a space

is left vacant. The sensor's off-delay timer is user-configurable

from any location using the Daintree Controls Software (DCS)

web application, eliminating the need for on-site, manual

sensor adjustment.

The WOS2-CM-S provides the standard coverage area, 500SF

with a 360 degree (lateral) coverage. The WOS2-CM-E provides

an extended coverage area of up to 1000SF.

Occupancy

Sensor

Lens

Utility

Button

Wireless Occupancy

Network LED

(green)

Infrared Detection

&Test Mode LED

(red)

CAUTION

Risk of injury. Wear safety glasses and gloves during installation and

servicing.

Installation Process

• Keep the sensor lens clean. Avoid touching the sensor lens.

• After first-time installation or reinstallation of a new battery,

allow up to three minutes for initialization.

1. Determine the mounting local on for the sensor based on day

light availability and task area. See Placement for details.

2. Remove the sensor from the base by twisting it. Locate the

sensor's IEEE address on the label inside the base. Record the

sensor's IEEE address in its local on the facility floor plan.

3. Attach the mounting base to the ceiling in the specified location.

Be sure the label is visible after mounting the base.

4. Install the batteries in the orientation (+ -) shown on

the bottom of the battery compartments.

5. Secure the sensor to the ceiling by twisting it onto the base.

6. After the batteries have been installed for at least 3 minutes,

initiate the Installation Test Mode: Momentarily press the

Utility button. The green LED flashes once then the red

LED flashes each time the sensor detects motion. (The test

mode times out after 5 minutes.)

Installation Guide

WOS2-CM | DT108

Base