Daintree GE Lumination LSA Series Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Daintree GE Lumination LSA Series. Daintree GE Lumination LSA Series 8 halaman.

Halaman Cetak

COMPONENTS SUPPLIED AND IDENTIFICATION

WIT100

• T1 - Daintree One Sensor

• TT - Daintree EZ Connect

Sensor

• CMP Cable

• Identification sticker labels

NOTE:

• All cables are CMP (Plenum) rated.

• Identification sticker labels are to be placed on or near luminaire and on a floor plan for mapping

OPTION A - NON ENCLOSED SENSOR INSTALLATION

SENSOR ACCESSORY INSTALLATION WITH GE CURRENT LED FIXTURE (SQ OPTION)

DISCONNECT POWER

Disconnect incoming power to the fixture at the

panel

WIZ100

• TZ - Daintree Enterprise

Sensor

• CMP Cable

• Identification sticker labels

Mounting Option – Using ONLY CMP

(Plenum) Rated Cable

Make a hole in ceiling where sensor is to be

mounted. It is recommended that the diameter of

the hole be slightly smaller than the outer

diameter of the sensor body. The recommended

diameter of the hole should be approximately

5/8" or 16mm. The sensor should be wedged into

softer (e.g. drywall or ceiling tile) material for

extra grip. The sensor will have either snap arms

or a nut to fasten to ceiling.

• TM - Daintree Enterprise

Multi-Sensor

• CMP Cable

• Identification sticker labels

INSTALL SENSOR UNIT DIRECTLY

INTO CEILING

WMZ10

Hole in ceiling – up

to installer on

where to place the

hole next to

luminaire