DSC IMPASSA Manual Pemrograman - Halaman 4

Jelajahi secara online atau unduh pdf Manual Pemrograman untuk Sistem Keamanan DSC IMPASSA. DSC IMPASSA 5 halaman. Self-contained 2-way wireless security system
Juga untuk DSC IMPASSA: Panduan Instalasi Mulai Cepat (2 halaman)

Halaman Cetak

Created by:

FYI: Before exiting, if you are also programming a key fob, you will press and hold the

arm and disarm buttons until the control panel asks you to verify the ESN Number. After

confirming the ESN number by pressing (*), the display will then ask for a key fob number

and you will just enter 01 for the first key fob and if you have another key fob that will be

02, the display panel will be ready to enroll another device. I f y o u h a v e s i r e n s ,

y o u w i l l a l s o t a m p e r t h e m i n t h i s s e c t i o n a s w e l l t o e n r o l l

t h e m . After you have enrolled and confirmed each device hit (# # #) to exit.

Entry/Exit Delays (Program Section 005)

Most doors use an exit/entry delay. This will give you time to exit your premises before

the system arms and will also give you an entry delay when you enter (You must enter

through a door that is on a delayed entry). You will enter into programming by pressing

*8 and then enter the Installer Code which is 5555. Programming Section 005 will allow

us to change the delay times. We want our Sample Alarm for demonstration purposes to

have 30 second delays for entry and exit.

So here is what we will enter on our Sample Alarm: *8-5555-005-01-030-000-030

The numbers you just entered are *8 for programming-5555 for installer code-005 is the

section # for the entry/exit delays-01 is indicating partition 1 (if you were programming

partition 2 you would enter 002)-030 is entry delay1 for 30 seconds- 000 is entry delay2

(which we do not have a 2 nd door delay time) – and the last 030 is the number of seconds

for your exit delay.

When entering programming, you always hit *8 5555. Below are additional sections

you need to go into:

Press 006 to change your installer code from the default setting of 5555. Enter the

section and just enter 4 new digits, after the 4th digit you should hear a triple beep, that

will bring you back to the "enter section" menu. This code is only used to get into

programming and nothing else. DO NOT LOSE OR FORGET THIS NUMBER AS

THIS IS YOUR ONLY WAY INTO PROGRAMMING.

Press 007 to change your master code from the default setting of 1234 and just enter 4

new digits, after the 4th digit you should hear a triple beep, that will bring you back to

the "enter section" menu. This code is what you use to arm and disarm the system

with. You can also create additional user codes with this code.

Press 015 - Then hit 2 (makes panic audible) and hit 7 to turn off TLM. Do not pay

attention to any other numbers displayed.

Now press # - 3 times to take you out of programming and to return to the main screen.

You should have a Green check mark.

And as far as basic programming you are done.

Created by:

Alarm System Store

http://alarmsystemstore.com