Foxconn T77N159 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Unit Kontrol Foxconn T77N159. Foxconn T77N159 5 halaman.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the

This device is intended only for OEM integrators under the following conditions:

The transmitter module may not be co-located with any other transmitter or antenna,

As long as the condition above is met, further transmitter test will not be required. However, the OEM integrator is still

responsible for testing their end-product for any additional compliance requirements required with this module installed

IMPORTANT NOTE: In the event that the condition can not be met (for example certain laptop configurations or

co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be

used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product

The final end product must be labeled in a visible area with the following: "Contains FCC ID: MCLT77N159".

The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF

module in the user's manual of the end product which integrates this module.

The end user manual shall include all required regulatory information/warning as show in this manual.

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，

並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率

射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

本模組於取得認證後將依規定於模組本體標示審合格籤，並要求平台上標示「本產品內含射頻

user's authority to operate this equipment.

(for example, digital device emissions, PC peripheral requirements, etc.).

(including the transmitter) and obtaining a separate FCC authorization.

Manual Information To the End User

大功率或變更原設計之特性及功能。

End Product Labeling

台灣警語 : : : :

模組：ID 編號」