DSC PC2580 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Keamanan DSC PC2580. DSC PC2580 13 halaman.

Halaman Cetak
Disarming the System with the LCD600 Keypad
Enter the premises through the Entry-Exit Zone and go to the keypad. The
message shown here will be displayed. Enter an Access Code before the
Entry Delay expires.
This message will be displayed to indicate that the system has been
disarmed, and that there were no alarms or trouble conditions during the
time the system was armed. This message will be displayed for 5 seconds.
After 5 seconds, this message will be displayed.
If there is a Trouble Condition Present:
This message will be displayed if there is a trouble condition present. Refer
to Displaying Trouble Conditions for instructions on how to display and
correct trouble conditions.
If there was an Alarm:
If a one or more zones went into alarm while the system was armed, a
message similar to the one shown here will be displayed. Use the [<] and
[>] Keys to scroll through the list of zones that went into alarm.
After viewing the zones that went into alarm, this message will be displayed
if there are still unsecured zones on the system. Use the [<] and [>] Keys
to scroll through the list of open zones.
Resetting Smoke Detectors with the LCD600 Keypad
If the Fire Alarm sounds at night, do not investigate the alarm: follow your evacuation plan immediately.
Go to a neighbour and call the fire brigade.
Smoke detectors installed on your system may be reset after a false alarm using the [
smoke detectors to normal, first clear all products of combustion from the detectors.
Press the [
to the message shown here.
Press and hold down the [4] Key for several seconds. If the detectors are clear of smoke, they will return to
normal. If the detectors still have smoke in them, the alarm will sound again. If the alarm sounds again, first
ensure that there is no threat of fire; you may then silence the alarm and reset the smoke detectors.
18
∗
][4] command. To reset
∗
] Key to enter the User Functions List. Use the [>] Key to scroll
Memory
Bypass
F
A
P
Trouble Conditions
Zone Light
Trouble
1
Low Battery
2
Mains AC Power
3
Keypad Tamper
4
Telephone Line
5
Unsuccessful
Communication
6
Bell Circuit
7
Smoke Detector Circuit
8
Reset Clock
When finished viewing troubles, press the [#] key.
Ready
Fire
Program
Trouble
Armed
Press [#]:
• when an error is made in entering an Access
Code, then enter the code again
• to return to "Ready" after using [
[F] Key: Press and hold this key for 2 seconds to
sound an [F] Key alarm
[A] Key: Press and hold this key for 2 seconds to
generate an [A] Key alarm
[P] Key: Press and hold this key for 2 seconds to
generate a [P] Key alarm.
These keys must be enabled by your Installer
before they become functional. Your Installer
will tell you how these keys operate on your
system.
∗
] commands
7