DSC PC5108L Panduan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Keamanan DSC PC5108L. DSC PC5108L 17 halaman.

Halaman Cetak

1. How to Program

Testing and Troubleshooting

5.1 Camera Testing

Cameras connected to the PC5108L can be tested on a regular basis.

The DLM-4L must be connected in order to use the testing feature.

Each camera must be enabled for testing. There is one Camera X

Test Enable/Disable option for each camera. Not all cameras must

be selected for testing. By default, the test feature is enabled for each

camera.

If Periodic Camera Test Enable/Disable

Periodic Camera Test Enable/Disable

Periodic Camera Test Enable/Disable is ON, a camera test will

Periodic Camera Test Enable/Disable

occur every 30 minutes. When OFF, there are camera tests:

1. Upon a system test: This test is user-initiated. See the PC5015

Instruction Manual for testing instructions.

2. Upon exiting Installer's Programming.

The test will take up to five seconds to perform. If the camera test

result is successful, normal system operation will continue. If the

camera test produces bad results from any of the cameras, a system

trouble will be initiated. The message "Camera X Trouble" will be

logged to the event buffer. When the trouble condition has cleared,

the message "Camera X Trouble Restore" will be logged.

A bad camera test result could be due to a number of factors, includ-

ing bad camera wiring, loss of power to the camera or a faulty unit.

To test the Downlook Remote Trigger feature, perform the following:

1. Enter [*][8][Installer's Code][906].

2. Press number keys [1]-[4] to transmit remote trigger script via

the appropriate path:

[1] telephone number 1 via landline

[2] telephone number 2 via landline

[3] telephone number 1 via LINKS

[4] telephone number 2 via LINKS

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Camera X Test Enable/Disable ................................... Subsection [60]

Periodic Camera Test Enable/Disable ........... Section [017] Option [7]

Local Test of Downlook Remote Trigger ......................... Section [906]

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

5.3 Software Default

To restore the PC5108L programming to the factory default settings,

perform the following:

1. Enter PC5108L module programming by pressing

[*][8][Installer's Code][806].

2. Enter programming subsection [99].

3. Enter [55]. Once [55] is entered, the module's default

programming will be restored.

For instructions on restoring the default programming of the main

panel or any other connected module, see the PC5015 Installation

Manual.