DSC PowerSeries LCD5511 Buku Petunjuk

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Keamanan DSC PowerSeries LCD5511. DSC PowerSeries LCD5511 12 halaman. Dsc lcd5511 keypad instruction manual
Juga untuk DSC PowerSeries LCD5511: Buku Petunjuk (20 halaman), Petunjuk Instalasi (4 halaman), Petunjuk Instalasi (4 halaman), Petunjuk Instalasi (4 halaman), Menggunakan (2 halaman)

DSC PowerSeries LCD5511 Buku Petunjuk

Using the LCD5511 Keypad

WARNING: Please refer to the System Instruction Manual for information on limita-
tions regarding product use and function and information on the limitations as to lia-
bility of the manufacturer.
and how to use it, please read your system's In-
struction Manual. Test system weekly and have
any system trouble conditions corrected by
your alarm installer.

1. Display

AC is present
Alarm(s) in memory
Fire alarm(s) in memory
System armed
Night mode
System armed
in Away mode
System armed
in Stay mode

2. System Lights

Ready Light (Green)
If the Ready light is ON, the system is ready for
arming. The system cannot be armed unless
the Ready light is ON.
Armed Light (Red)
If the Armed light is ON, the system has been
armed successfully.
The
LCD5511
shows the status
1. Display
of your security
2. System
system using an
Lights
LCD
display,
along with fixed
3. Number
Pad
symbols
numbers.
This
instruction
sheet describes
the
basic
tures of the key-
pad. For more
detailed informa-
tion on your se-
curity
Zone(s) open
Zone(s)
bypassed
System Trouble
Door Chime
Programming
in progress
Trouble display

3. Number Pad

Use the number pad to enter your code, and to
access system functions. To exit a function and
return to the Ready state, press
a function press
4. Emergency Keys
and
Press and hold both keys simultaneously for
2 seconds to send the following messages:
fea-
NOTE: *(All Keypads) The Fire, Auxiliary and
system
Panic keys will NOT function unless programmed
by the installer. If these keys are in service and the
installer has enabled audible feedback, holding
down the key for two seconds will cause the keypad
sounder to beep indicating that the input has been
accepted and sent.
5. Function Buttons (
If your installer has enabled them, you can use
the function buttons to access the Stay arm,
Away arm, Door Chime features (your installer
may program other functions for these but-
tons). Press and hold the appropriate button
for two seconds. Refer to your Installation Man-
ual for more information on these features.
Using the LCD5511 Keypad
The LCD5511 works similarly to the other key-
pads described in your system's Instruction
Manual. For more information on individual func-
tions, see your system's Instruction Manual.
Viewing Open Zones
Before you can arm your system, all the zones
must be closed. If some zones are currently
open, the keypad will display
Ready light will be off. To see the numbers of
the open zones, press
your system, go to the open zones and close all
doors and windows, and make sure no one is
present in zones with motion detectors.
Viewing Zones in Alarm Memory
If there is an alarm on your system the keypad
will display
the zones affected. To view zones in memory,
press
.
Fire Message
Auxiliary Message
Panic Message
. Before you try to arm
and will scroll the numbers of
.
. To select
)
, and the