DSC PowerSeries LED5511 Buku Petunjuk - Halaman 13

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Keamanan DSC PowerSeries LED5511. DSC PowerSeries LED5511 20 halaman. V4.2
Juga untuk DSC PowerSeries LED5511: Petunjuk Instalasi (2 halaman)

Halaman Cetak

[3] Auto-arm Time

The system can be programmed to arm at a programmed time each day, per partition. Upon entry of

this section, enter 4 digits for the 24-hour Auto-arm time for each day of the week.

At the selected auto-arm time, the keypad buzzers will sound for a programmed amount of time

(programmable by the installer only) to warn that an auto-arm is in progress. The bell can also be

programmed to squawk once every 10 seconds during this warning period. When the warning

period is complete, the system will arm with no exit delay and in the Away Mode.

Auto-arming can be cancelled or postponed by entering a valid access code only, during the pro-

grammed warning period. Auto-arming will be attempted at the same time the next day. When the

auto-arming process is cancelled or postponed, the Auto-arm Cancellation Reporting Code will be

transmitted (if programmed).

If arming is inhibited by one of the following, the Auto-arm Cancellation transmission will be com-

municated.

- AC / DC Inhibit Arm

- Latching System Tampers

- Zone Expander Supervisory Fault

[4] System Test

The system's Bell Output (2s), Keypad Lights and Communicator are tested. This test will also mea-

sure the panel's standby battery.

[5] Enable DLS / Allow System Service

If enabled, the installer will be able to access Installer Programming by DLS. In case of DLS access this

provides a window where rings will be detected by the panel. The DLS window will remain open for

6hrs, during which time the installer will be able to enter DLS an unlimited number of times. After

the 6-hr window has expired, Installer's Programming will be unavailable again until the window is

re-opened.

[6] User Call-up

If enabled by the Installer, the panel will make 1 attempt to call the downloading computer. The

downloading computer must be waiting for the panel to call before downloading can be performed.

[7] For Future Use

[8] For Future Use