DAITEM SH423AX Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Keamanan DAITEM SH423AX. DAITEM SH423AX 13 halaman. Siren external

Halaman Cetak
1. Introduction
IMPORTANT
• Some functions are only available with versions 2.0.0 or later (press
check the version).
• The operating differences with former ranges are described in the compatibility booklet available in the Daitem installers
section at www.daitem.co.uk.
In addition to the protection provided by the control panel with built-in siren and keypad, the external siren with flashing
strobe makes it possible to:
• deters intruders and alert neighbours (external sounding mode),
• easily locate the alarm (flashing strobe).
If a fire is detected, the siren is triggered for 5 minutes in fire sounding mode.
Thanks to its built-in transmitter, the siren informs the control panel when it has a battery problem.
If somebody attempts to pull the siren off the wall, it sounds and then triggers all the alerts and deterrents via the control panel.

2. Preparing the siren

2.1 Tooling required

2.2 Opening the siren and connecting the power supply

1. Insert a screwdriver into the bottom right-hand
corner between the base and the siren and
apply pressure
to open the siren.
3. Lift up the screw cover and
remove the screw from its
slot.
Screw cover
7. Reposition the
battery cover and
screw it in place
using one of the
screws (A).
Screw slot
6 mm
PZ 2
2. Place the siren on a flat surface, remove
the base by inclining it at a 45° angle (A)
and pull it downwards (B).
45°
4. Guarantee sticker
Remove the pre-cut part of
the sticker and stick it to the
guarantee certificate in the
user manual supplied with the
control panel. If you are
adding the siren to an existing
system, use the guarantee
sticker provided with this
product.
SH421AX
A12260A0963C
SH421AX
Coller sur certif
A12260A0963C
8. Position the locking screw in its slot.
A
IMPORTANT: the fixing screws
and wall plugs are not supplied.
A
5. Position the power pack on the guide rails.
6. Slide the power pack to the left until it is
locked into place.
Locking screw slot
Siren opening
2
on the control panel keypad to
B
Guarantee
sticker
Unlocking key
Locking screw
and battery
cover screw
Bottom view of siren