DAITEM SJ608AX Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Keamanan DAITEM SJ608AX. DAITEM SJ608AX 8 halaman. 2 function remote keyfob with information feedback, bi-protocol 4 function remote keyfob with information feedback,8 function 4 key remote keyfob with information feedback

Halaman Cetak

1. Changing the Battery

The keys are conﬁgured to issue the following commands:

Keyfob reference

SH602AX

SJ604AX

Cursor

White

in top

marker

position

SJ608AX

Cursor

Blue

in bottom

marker

position

IMPORTANT: when the cursor is in the middle position, the keys are in protected mode and cannot issue radio commands.

• Speciﬁc feature of the SJ608AX keyfob

When a command n° has been conﬁgured (TwinBand

cursor is in the bottom position while the other keys are automatically conﬁgured to be disabled (command n° 44 for

TwinBand

radio).

Example: the cursor is in the bottom position and the P1 key parameter is set for the "Silent alarm" command. The other

three keys are disabled.

SJ608AX keyfob

Blue

Cursor

marker

in bottom

position

• The keyfob has a three-colour LED on its front face indicating:

- radio transmission when a key is pressed,

- information feedback from the system being controlled or, failing

this, conﬁrmation of receipt,

- the battery status.

This three-colour LED can also be used for different parameter

settings.

• The keyfob has a pushbutton for:

- returning to the keyfob's factory conﬁguration,

- creating or deleting a radio link between each key and Optwin

wireless devices (external receiver and doorphone).

2. Preparation

1. To connect the battery, slide the rear base down

by about 5 mm and then pull it up.

3. Put the rear base back by sliding it upwards until it locks

into position.

5. Guarantee sticker

Remove the pre-cut part of the sticker and stick it on to the guarantee

certiﬁcate inside the user manual supplied with the control panel. If you

are adding to an existing system, use the guarantee certiﬁcate supplied

with this product.

Factory conﬁguration of keys

OFF

Arm

Disarm

Arm

Disarm

Arm

Disarm

Arm

Disarm

) and a radio link created (Optwin

Factory conﬁguration of keys

OFF

Key disabled

Hole for cord

2. Position the battery (supplied).

4. Insert the cord.

Partially arm 1

) for one of the keys, then the

Silent alarm

Key disabled

Three-colour

LED

Pushbutton for

return to factory

configuration and

creation of radio

link (Optwin

)

IMPORTANT:

make sure you

position the

battery the right

way round with

the "+" facing up.

SJ604AX

Coller sur certif

Guarantee sticker

A1042A047879

Alert