DAITEM 172-21X Panduan Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sensor Keamanan DAITEM 172-21X. DAITEM 172-21X 8 halaman. Infared motion detector
Juga untuk DAITEM 172-21X: Panduan Instalasi (18 halaman)
Halaman Cetak3. Programming
IMPORTANT: during recognition programming, the product to be programmed for use with the control panel does not need to
be placed next to it. In fact, we recommend you place the product at a short distance from the control panel (at least 2 meters
away).
Programming enables the detector to be recognised by the control panel.
1. To programme the detector the control panel must be in installation mode. If it is not, ask the user to press:
master code
(0000 by default)
2. Programme the device as follows:
then
Press and hold the "test"
#
Press
then
on
*
button until the control
the control panel
panel responds
keypad
IMPORTANT: the control panel indicates there is an error by emitting 3 short beeps. When this happens programming
should be carried out again.
• Example: programming of 1st detector allocated to Gr. 2 with immediate triggering.
then
10 s max.
then
engineer installer code
(1111 by default)
"detector X"
"group?"
10 s max.
The control panel waits
for a group to be chosen
(from 1 to 8)*. Choose the
group by pressing the
corresponding numeral on the
control panel keypad
"detector 1"
"group?"
"beep, installation
"time delay?"
*
to
to
* according to the
type of control panel
Choose the type of triggering:
0: immediate
1: delayed
2: combined
Use the control panel keypad
to select the type
"beep, detector
"time delay?"
1, group 2,
immediate"
IMPORTANT: the control panel indicates
there is an error by emitting 3 short
beeps. When this happens programming
should be carried out again.
3
mode"
"beep, detector X,
group Y immediate
(or delayed
or combined)"
The control panel
gives a voice
message to confirm