DSC WLS904-433 Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Sensor Keamanan DSC WLS904-433. DSC WLS904-433 4 halaman. Wireless motion

Halaman Cetak

WLS904-418

WLS904-433

Wireless Motion Detector

INSTALLATION INSTRUCTIONS

Each WLS904 motion detector should be located so that it provides

optimal coverage of the intended area. Refer to Changing Motion Detector

Lenses below for information on the four lenses available for the WLS904

Motion Detector. When locating motion detectors, observe the following:

• For the Wall-to-Wall, Corridor and Curtain Lenses, the Mounting Height

should be 6-10 ft./ 2-3 m from the floor. The nominal mounting height is

7.5 ft./ 2.3 m.

• For the Pet Alley Lens only, the Mounting Height should be 4-5 ft./1.2-1.5m

from the floor.

• Do not aim the detector at reflective surfaces such as mirrors or

windows. This may distort the coverage pattern or reflect sunlight

directly onto the detector. Avoid locations where the detector may be

exposed to direct or reflected sunlight.

• Avoid locations that are subject to direct air flow, such as near an air duct outlet.

• Do not locate the detector near sources of steam or oil vapor, such as

a stove or fryer.

• Do not obscure the Detector's coverage pattern with large objects within

the detection area. If you can't see the detector, it can't see you.

• For indoor use only

• Dead zone 6"/15 cm

NOTE: No detector should be mounted without first performing a

module placement test to determine that it is in range of the

wireless receiver. See the Placement Test instructions in the

Instruction Sheet for your receiver, or in the installation manual for

your system.

When a location has been determined,

remove the plastic from the mounting

holes and locate the backplate on the

wall and mark screw locations. It is

suggested that wall anchors be used for

all screw locations. Secure the backplate

to the wall, and then secure the enrolled

Detector to its backplate.

Please refer to the System Installation Manual for information on

limitations regarding product use and function and information

on the limitations as to liability of the manufacturer.

• W A R N I N G •

ENSURE PROPER

ORIENTATION OF

BACKPLATE.

MOUNTING HOLE

KNOCKOUTS

CORNER MOUNTING

KNOCKOUTS

Motion Detector Backplate