Anslut 016711 Panduan Petunjuk Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Lampu Kerja Anslut 016711. Anslut 016711 10 halaman. Battery-powered led christmas tree lights

Halaman Cetak
EN
USE
BEFORE USE
1.
The lights are fastened on the branches of
the tree with clips in the base.
2.
Check that the lights are firmly in place.
3.
Make sure there are no obstructions
between the remote control and the
lights. The range of the remote control
will be reduced if the charge level of
the batteries is low, or if there are
obstructions between the remote control
and the lights.
HOW TO USE
The lights are switched on with the buttons
on the remote control, either with constant
warm white or amber, or with alternating
colour (RGB). The brightness can be set with
the + and – buttons for the constant colours
warm white and amber. Press the OFF button
to switch off the lights. An irregular brightness
that resembles flickering flames can be set for
the constant colours warm white and amber –
push the button for warm white until the light
begins to "flicker".

MAINTENANCE

INSERTING/REPLACING BATTERIES
Light (receiver)
1.
Unscrew the light from its base
(anticlockwise) and remove the
discharged battery.
2.
Insert a 1.5 V battery AAA with the positive
terminal pointing forwards in the direction
of insertion.
3.
Carefully screw the light back on its base.
Do not overtighten, this can damage the
thread. The light goes on when it is screwed
together if the battery is correctly inserted.
10
Remote control (transmitter)
NOTE:
Always replace both batteries at the same
time. Do not mix new and old batteries,
or different types of batteries.
1.
Push the battery cover on the back of
the remote control in the direction of
the arrow and remove it. Remove the
discharged batteries.
2.
Insert two 1.5 V batteries AAA with the
correct polarity as shown by the markings
(+/–) in the battery compartment.
3.
Replace the battery cover.