3M Littmann Lightweight II S.E. Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Medis 3M Littmann Lightweight II S.E.. 3M Littmann Lightweight II S.E. 6 halaman. Stethoscope

stethoscope utilizes a unique design for
attaching the eartip to the eartube. The eartips
are pushed on to the end of the eartube and
snapped firmly into place. To remove, pull
firmly on the eartip.

Headset Adjustment:

Your Littmann
stethoscope is designed to
provide a comfortable,
acoustically sealed ear fit.
Notice that the ear tubes
are set to accommodate
Correct
the typical anatomy of the
ear canal. The eartips
should point in a forward
direction as you insert
them into your ear canals.
Incorrect
Incorrect
To reduce spring tension
in the headset, hold each
ear tube at the bend near
the eartip and gradually
pull apart until fully
extended.
To increase spring
tension, grasp the headset
with one hand where the
ear tubes enter the plastic
tubing and squeeze until
the plastic tubing on one
ear tube touches the other.
Repeat as necessary.
Removing the Diaphragm and
Cleaning the Chestpiece:
wipe with alcohol. Wipe chestpiece surfaces
with alcohol or soapy water. Dry all parts and
surfaces thoroughly before reassembly.
Assembly and Replacement of the
Diaphragm:
3
With the diaphragm side
up, push the rim at one
point with both thumbs
and roll the rim off the
edge of the chestpiece.
Remove the diaphragm
from the rim and clean
parts in soapy water or
Using your fingertip,
apply a small amount of
talcum powder to the
inside surface of the
flexible edge of the
diaphragm then align the
rim and diaphragm as a
unit. This will facilitate
assembly and maintain
smooth and quiet
low/high frequency
alternation. Snap the
diaphragm with your
fingers to remove excess
talcum powder. Insert
the flexible edge of the
diaphragm into the
groove of the rim. This
is best accomplished by
starting with the rim
positioned above the
legible side of the
diaphragm. Visually