Foxfury Lighting Solutions Taker B70 Panduan Produk - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Produk untuk Senter Foxfury Lighting Solutions Taker B70. Foxfury Lighting Solutions Taker B70 12 halaman. Shield light

Halaman Cetak

BATTERIES

The Taker B70 uses three (3) or six (6) CR123 batteries. As long as there
are at least three (3) installed, the light will function.
Using three (3) CR123 batteries decreases the battery life by half, but
does not effect the light intensity .
Mixing of new and used, or different brand batteries is not recommended
as this could lead to leakage or explosion.

BATTERY INSTALLATION AND REPLACEMENT

1
2
3
1.
Twist the Battery Cap (at both ends of the handle) in a counter-clockwise
1
direction to remove them.
2.
Insert three (3) batteries (with the negative end first) into either side of the
2
handle (respect appropriate polarity when installing).
If installing six (6) batteries (doubling battery life), then repeat step 2
one more time on the opposite side of the handle.
3.
Re-install the Battery Cap(s) by twisting in a clockwise direction (make
3
sure the Battery Cap(s) are tightly sealed).
Test the light's performance and function by activating the Power/
Mode Switch (located under the Grip).
5