Anslut 422-198 Petunjuk Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Lentera Anslut 422-198. Anslut 422-198 19 halaman. Solar cell light

• A built-in light sensor means that the light is off during daylight hours and automatically comes

on when it gets dark�

• During daylight the solar panel converts the sunlight to energy which is used to charge the battery�

In the evening, the light automatically comes on and is powered by the charged battery�

• Location, weather and time of year all affect how long the battery can power the light�

• During the winter months, the solar cell light receives a restricted amount of sunlight,

and the lighting time is consequently also limited during the winter�

• The light is powered by solar energy and is easy to install� No cables are needed�

• The light turns on and off automatically�

NoTE!

• Position the solar cell light in a location that receives a lot of sunlight� If the solar cell light is put in

a shady place, the batteries will not fully charge, resulting in shorter illumination times�

• Do not position the solar cell light close to sources of light such as streetlamps, as this might cause

the light to not come on� There should be a distance of at least 1�5 metres between solar cell lights�

Placing them more closely together can affect their functioning and the light might start flickering�

1�

Assemble the parts as shown in the figure below�

2�

Grasp the metal bottom section firmly and press the black spear down into the ground�

3�

Bear in mind that the light must be turned off during the first two days of charging�

The solar cell light can be turned on after 48 hours�

NoTE! The rechargeable battery must be fully charged to function correctly� If the battery is repeatedly

only partially charged, its service life will be considerably shortened�

ASSEmBLy