If An Alarm Sounds
Fire Alarm
If your system has been installed with fire detectors and the alarm sounds in a pulsing mode, follow
your emergency evacuation plan immediately (see "Fire Escape Planning" on page 15).
Intrusion Alarm
If an intrusion alarm sounds, indicated by a continuous bell or siren, the alarm may be silenced by
entering your access code. If the alarm was unintentional, call local authorities or central station
immediately to avoid an unnecessary response.
You can determine the source of the alarm by following the instructions in the "Disarming" section (see
page 6). Once the source of the alarm has been corrected, the panel can be restored to its original
Armed state.
Function Keys
Each keypad has five function keys, located to the right of the number pad, which allow easy single-
button activation of the most commonly used features. If these keys have been enabled by your
installer , you can execute their programmed function by pressing and holding the corresponding key
for two seconds.
For information regarding the operation of the function keys, talk to your alarm installer.
Programming Security Codes
Programming codes from an LED Keypad:
The Master Code
To program the Master Code, enter [ ][5][current Master Code][40][new Master Code]. The Master
Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only.
Press [#] to return to the Ready state.
Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Codes
Up to 32 additional access codes (01 through 32) may be programmed.
To program a new code:
Enter [ ][5][Master Code][code number 01 to 32][new access code]. The code number is a double
digit from 01 to 32. Access codes must be four digits unless otherwise indicated by your installer.
Enter digits 0 through 9 only. Press [#] to return to the Ready state.
If an access code already exists for the code number you have selected, it will be replaced by the
new code. Be sure to record your new code(s) on the "System Information" page in this book.
To erase a code:
Enter [ ][5][Master Code][code number 01 to 32][ ]. Press [#] to return to the Ready state. The
Master Code cannot be erased.
7
Continued on page 10...
Halaman Cetak